Silicon Application by Sorghum Through the Alleviation of Stress-Induced Increase in Hydraulic Resistance

In this study, it was verified whether silicon (Si) affected plant hydraulic resistance, which was one of the significant factors affecting water uptake. Sorghum bicolor (L.) Moench. was grown hydroponically under varying silicon levels and exposed to osmotic stresses. Under osmotic stress, reduction in growth, photosynthesis, and transpiration were alleviated as supplied silicon levels increased. These alleviative effects were ascribed to enhancement of water uptake. Although shoot/root ratio was not affected by silicon, estimated apparent hydraulic resistance was lower in silicon-supplied sorghum than silicon-deficient one under osmotic stress. Simultaneous measurement of transpiration and water uptake rates indicated that under osmotic stress silicon-deficient sorghums showed unbalanced water relation that transpiration rate exceeded water uptake rate, while they were balanced in silicon-supplied sorghums. The results indicated that silicon improved hydraulic resistance, allowing sorghum to avoid from decrease in water uptake rate that happens to silicon-deficient sorghum under water stress.     

Clay minerals of sediments in the Yatsushiro bay

Since three decades ago it has been established by numerous investigators⁴,⁷,⁹⁾ that the general Process of formation of clay minerals is different between the marine and terrestrial conditions, and that the clays of the marine origin are, in general, of illitic type, whereas those of the terrestrial are of kaolin group. In previous communications,¹,²⁾ it was reported that clay fractions of the soil and mud from the Ariake Sea are characterized by the abundance of minerals of illite-montmorin series (montmorin refers to montmorillonite group after Jackson and Sherman⁸⁾, being different from most terrestrial soils in Kyushu. The matter seems to be of some importance because the Presence of montmorin, even in a relatively small quantity, is likely to exercise a considerable, influence on the behaviour and properties of the clay and the fertility of the soil. The soils of the reclaimed land of the Sea are not only productive, Whether they are clayey or sandy, but also they have been approved to be powerful improving materials for the degraded paddy soils, so-called “Akiochi” soils by several field experiments.     

Imogolite in some ando soils

It was reported in a preceding paper⁷⁾ that the Ando soils from Uemura, Choyo, and Kawanishi contained an unknown mineral colloid which was distinctly different in some respects from coexisting allophane. In the Uemura soil, this clay fraction made up more than 20 per cent of the total clay and more than 6 per cent of the soil⁷⁾.     

Influence of pH on the formation of the hydroxy Al-montmorillonite complex

The presence of so-valled chlorite-like minerals has been reported in many soils of not only acid but also of alkaline reaction (1). The minerals have been designated by, many terms, for example, dioctahedral vermiculite (2), dioctahedral analogue of vermiculite (3), 14A mineral (4), chlorite-like mineral (5), interstratified chlorite-vermiculite (6), intergradient chlorite-expansible 2:1 layer silicate, intergradient chlorite-vermiculite, intergradient chlorite-vermiculite-montmorillonite, intergrade, or interlayered vermiculite (7), and 2: 1-2: 2 intergrade (1). The minerals designated by these terms are evidently of the same category, and some of them are synonymous. Although they are of intermediate properties, between true chlorite and true vermiculite or montomorillonite, they could be regarded as an independent group of minerals in the course of pedochemical weathering. Jackson (1), for instance, has given the minerals the position of “weathering index 9”, placing them between vermiculite and kaolin as equivalent to montmorillonite, or secondary chlorite and kaolin in his weathering sequence. An explanation of the diagenesis of the minerals has been recently attempted by synthesis of the chlorite-like structures from montmorillonite (8), (9) and vermiculite (10) and mineralogical analyses of soil clay fractions (7).     

Mineralogy of gel-like substance in the pumice bed in Kanuma and Kitakami Districts

A characteristic gel-like substance has been noticed around weathered pumice grains in the pumice beds of Kanuma near Utsunomiya and of Kitakami, Iwate prefecture. This substance was first studied by SHIOIRI (6) in 1934, and reported as allophane according to its chemical composition, refractive index, and dye-adsorbing nature similar to the colloid of volcanic ash soils of the Onji-type. Recently, KUWANO and MATSUI (5) remarked that the colloidal film in the Kanuma and Imaichi pumice beds diffracted x-rays at about 8 and 33 Å, and they presumed that this substance might be an early transitional material from allophane to some crystalline clay minerals. KANNO (2) and KANNO et al. (3) examined this gel-like substance from Imaichi and Kitakami districts precisely by the x-ray diffraction, differential thermal, infrared spectroscopical, electron microscopical, and chemical methods, and they concluded that the substance was a mixture of poorly crystallized montmorillonite, allophane in various weathering stages, and free sesquioxide, although there was no positive evidence of montmorillonite. YOSHINAGA and AOMINE (7) noticed that the properties of imogolite designated by themselves bore a striking likeness to those of the gel-like substance reported by KANNO et al. (3), and they considered that both substances were essentially of the same kind irrespective of occurrence.     

Excellent oil absorbent kapok [Ceiba pentandra (L.) Gaertn.] fiber: fiber structure, chemical characteristics, and application

The study focused on kapok [Ceiba pentandra (L.) Gaertn.] fruit as a biomass for effective utilization. Kapok fruits were harvested just before full maturation at the campus of University of the Philippines Los Banos and in southern Vietnam. The kapok fibers are utilized locally as fiberfill in pillows, quilts, and some soft toys. Kapok fiber was isolated and analyzed microscopically, and the physicochemical properties were determined by spectroscopic methods. Some tests were done to determine the effective utilization of kapok fiber. Microscopic analysis of the higher structure of kapok fiber gave quite different results from cotton fiber, which has a significantly homogeneous hollow tube shape and is composed of cellulose (35 % dry fiber), xylan (22%), and lignin (21.5%). Kapok fiber is characterized by having a high level of acetyl groups (13.0%). Usually cell walls of plants contain about 1%–2% of acetyl groups attached to noncellulosic polysaccharides. Kapok fiber is significantly hydrophobic and does not get wet with water. Thus, the absorptivity of oil was tested. The fiber selectively absorbed significant amounts of oil (40 g/g of fiber) from an oil suspension in freshwater and seawater. It is suggested that this fiber could be used to recover oil spilled in seawater.     

Influence of surface charge on viscosity behavior of cellulose microcrystal suspension

Microcrystalline cellulose with minimal surface charge was prepared from softwood kraft pulp via hydrolysis by 4N hydrochloric acid instead of sulfuric acid. To this material, sulfate ester groups as surface charge were introduced by treating with 55% (w/w) sulfuric acid. A treatment at 60°C for 2h gave nearly the same level of surface charge as that of the H₂SO₄ -hydrolyzed microcrystal. The number of sulfate groups were controlled by changing the H₂SO₄ treatment conditions. Although the microscopic size and shape of the microcrystalline particles were the same irrespective of the preparation method, the introduction of surface charge drastically reduced the viscosity and removed its time dependence. These changes in viscosity behavior are considered to result from charge-induced dispersion of loose aggregates existing in the initial charge-free microcrystals prepared by HCl hydrolysis.Part of this report was presented at the 48th annual meeting of the Japan Wood Research Society, Shizuoka, April 1998     

Comparison of glycerol, lactamide, acetamide and dimethylsulfoxide as cryoprotectants of Japanese white rabbit spermatozoa

The rabbit is considered to be a valuable laboratory animal. We compared glycerol, lactamide, acetamide, and dimethylsulfoxide (DMSO) as cryoprotectants in egg-yolk diluent of ejaculated Japanese white rabbit spermatozoa for improvement of sperm cryopreservation methods. Rabbit semen was frozen with 1.0 M glycerol, lactamide, acetamide, or DMSO in plastic straws. Forward progressive motility and plasma membrane integrity of the post-thaw spermatozoa were examined. The rate of forward progressive motile spermatozoa in lactamide (37.8 +/- 3.0%) was significantly (P<0.05) higher than in glycerol (17.0 +/- 3.3%). In addition, the rates of sperm plasma membrane integrity in lactamide and acetamide (35.9 +/- 3.3% and 30.2 +/- 3.0%, respectively) were significantly (P<0.05) higher than in glycerol (17.0 +/- 2.6%). The results indicate that 1.0 M lactamide and acetamide have higher cryoprotective effects than 1.0 M glycerol for cryopreservation of Japanese white rabbit spermatozoa.     

Positional effect of gene insertion on genetic stability of a clover yellow vein virus-based expression vector

The stability of the inserted genes in the viral expression vector varied depending on the sequence introduced and the position of insertion. Infectious cDNA to Clover yellow vein virus (pClYVV) was modified to insert a foreign gene at two independent sites: one, along with a polylinker, between the NIb and CP genes (pClYVV/CP/W) and the other between P1 and HC-Pro (pClYVV-Pst/CP). The green fluorescent protein (GFP) gene was inserted into either pClYVV/CP/W or pClYVV-Pst/CP. GFP gene was stably maintained and expressed in both vectors following serial passages in plants. Progeny viruses from both constructs accumulated in similar amounts and at rates of 70%–80% of that of the wild-type virus. On the other hand, progeny viruses carrying the human interferon- (hIFN) gene cloned in pClYVV-Pst/CP were genetically unstable owing to frequent deletions of the cloned gene during passage through plants. In contrast, the hIFN sequence cloned in pClYVV/CP/W was stably maintained in viruses after several passages in broad bean plants, and the progeny virus accumulated at the rate of about 50%–100% of that of the wild-type virus. The nucleotide sequence analyses indicated that the genetic instability of the inserted sequence results from homologous recombination of viral vector and inserted DNA sequences; it is not due to the inserted sequence alone.     

Mechanism of mercerization revealed by X-ray diffraction

We studied the crystalline conversion of cellulose fiber from cellulose I to cellulose II (mercerization) by X-ray diffraction, focusing on the putative chain-polarity conversion from parallel to antiparallel. The structural change of Na-cellulose was examined during stepwise changes in NaOH concentration. Either Na-cellulose I or Na-cellulose II was formed depending on the initial NaOH concentration. Once formed, both structures were stable and did not inter-convert to each other when the NaOH concentration was changed. Such stability indicates that the parallel-to-antiparallel conversion is not likely to take place in the crystalline region of Na-cellulose. Regeneration of cellulose II from both forms of alkali cellulose proceeded with the formation of 0.44 nm lattice plane corresponding to the sheet of (1 ¯1 0) plane of cellulose II, showing that the molecular stacking due to van der Waals' interaction is the driving force of the formation of cellulose II. A mechanism was proposed whereby the geometry of the cellulose molecule allows close fitting of the hydrophobic faces only in the antiparallel arrangement, thus driving formation of the antiparallel structure of cellulose II.This study was presented in part at the 47th Annual Meeting of the Japan Wood Research Society, Kochi, April 1997; and at the 6th Annual Meeting of the Cellulose Society of Japan, Tokyo, June 1999